Installing a new commercial door without taking a professional help may sound like a daunting task. But, when you have the basic information and knowledge on how the door works, you can start on your own. Make sure to get the right tools and ask your friend or a family member to help you.

Prepare Yourself for Installation

hammer, screwdriver and nails drawing

  • Read the manual before you start: This helps to comprehend the processes involved in professional¬†commercial doors installations in NJ so that you can anticipate the steps and prepare yourself for the task.
  • Keep the necessary parts ready: The garage doors come in full package. Be sure you have all parts before you start installing the door. It’s a good idea to arrange garage door parts into piles; it will be easier to recognize if something is missing. In case you see that some part is missing, contact the manufacturer immediately.
  • Gather additional tools required for installation: Additional tools include nails, power drill, hammer, screwdriver and screws of various sizes. You will also need a ladder to reach the upper parts of the door.
  • Prepare the first panel: Attach the hinges to the top of the first panel. Slide a roller into hinges on the panel. Pre-drill holes for hinges to connect the rest of the sections. Once you attach hinges to the bottom of each section, you can lay down the panel and connect it to its adjacent panel. Ensure lining up the part correctly and then pre-drill holes where the two panels or sections need to be connected.

Start with Installation

  • Place the first panel: Ensure choosing the right commercial door, which is wide enough to cover the opening, but shouldn’t surpass the opening. The commercial doors are available in standard sizes with seven feet high and nine feet wide. If your garage opening differs, you’ll need to order a customized commercial door.
  • Assemble the track according to the manufacturer’s instructions: Connect the separate parts according to the instructions. You can also read the instruction manual once again and start this procedure.
  • Install the vertical tracks: Install the rails by sliding the rollers. Make sure to keep the panel at the center and the track at the right level. Screw the track, but don’t tight them too much. You may require making little adjustment throughout the procedure.
  • Install the second panel: Unlike the first panel, the second panel doesn’t have hinges outside, hence install outside hinges and roller along with subsequent panels.
  • Install horizontal and curved tracks: Read the manufacturer’s instruction while installing horizontal and curved tracks. You may need to rest the horizontal track on top of the ladder. Check the track level and cut the rear track hanger length required to support the track and fix the track appropriately.

For more detailed instructions and helpful illustrations, go to this site.